Most customers want their pipe covers to hide valves.
If this is not possible, you may need a cutout or notch in the end of the cabinet for valves.
From a heating efficiency standpoint, and for best airflow, you’ll want the back
of the enclosure to sit out in front of the ¼ round, molding, and/or
baseboard woodwork where possible. If this is not practical,
notches will be needed to clear the obstacles.

We can provide special cutouts and/or notches in the ends of any pipe cover.
Fax or mail us a sketch, or call us toll-free, between 8 am and 5 pm, EST, M-F.

An unlimited range of custom colors are available.
Call us, or email a note. All pipe covers are powder-coated for superior durability.

Most customers "round-up" to the next full inch.
But if you want to use your fractional measurement, that’s fine with us. 
We're the only manufacturer of pipe covers that can accommodate fractions –
just call us at 800-543-7040.